• Wide supply connection – 11.0 to 28.0 Volts AC/DC
• Highly sensitive receiver input stage. When used with GLT433…. series transmitters and an ANT433S antenna, an operating range of 350 metres (980 ft) is possible.
• Two relay outputs. Both outputs can be operated simultaneously.
• Crystal controlled for high stability and performance.
• Uses micro-controller technology that can be re-programmed to suit unique applications.
• Momentary, flip-flop and latching output modes is user selectable.

Applications
• automatic gates, security, timer controlled outputs and simple on/off functions

Description
The GIGALINK™, is the most advanced Remote Control technology available in the world today. GIGALINK™ is an invention that has revolutionised the entire Remote Control technology including Elsema’s earlier version of FMT- … and FMR- … series. The GLR.... series state-of-the-art invention brings a new dimension in the world of Remote Control technology in domestic, commercial and industrial applications.

The innovative microcontroller technology replaces the traditional dip switch coding which eliminates any possible code grabbing. Special features such as over four billion code combinations, ability to program any number of transmitters to any of the receiver outputs, three user selectable modes, dual conversion superhet and operational over a wide voltage range all adds up to the most advanced and secure Remote Control available.

Four billion codes
The user can easily change the code on all the channels. Momentary joining the two CC pins on the receiver board sets all channels to one random code. One of 4,294,967,296 possibilities is selected.

Code Programming - Single
During single code programming, the 2-way dip switch selects the channel to be programmed. The table below shows the setting to select a different channel.

Dip Switch 1 Dip Switch 2 Setting Channel
(Output Relay)
OFF OFF 1
ON OFF 2

After selecting the correct channel, the receiver channel is ready to be single code programmed.

Follow the steps outlined in the receivers instruction sheet titled single code programming to complete the code programming.

Code Programming - Channelised
If all the receiver channels are to be programmed onto a multi channel transmitter, then follow the steps outlined in the receivers instruction sheet titled channelised code programming. This does not require the user to set the 2-way dip switch since all receiver channels will be programmed sequentially onto the transmitters channels.

The receiver power must be connected when single or channelised code programming.

When programming is completed and the GIGALINK cable is removed from the multi channel receiver-coding socket, the 2-way dip switch is used to select different output modes. This is described below.

Different Modes for the Output
Modes are user selectable from the 2-way dipswitch. Dipswitch 1 corresponds to relay channel 1 and dipswitch 2 corresponds to relay channel 2.