• Crystal Controlled
• Comprising of Receiving, Decoding & Relay-output Sections
• LARGE SCALE INTEGRATED CIRCUIT (LSI) is employed in the decoder section

Applications

• Remote control of garage doors, gates, lights, alarms

Click image to enlarge
Download Datasheet

Description
Products in the Range
Technical Data
Receiver Selection Table


Description

The FMR-240 is a crystal controlled single channel receiver, comprising of receiving, decoding and relay-output sections. A specially designed LARGE SCALE INTEGRATED CIRCUIT (LSI) is employed in the decoder section, which ensures operation at low supply voltage, highest reliability, associated with very low power drain.

The receiver works on a digitally encoded 27 MHz frequency modulated (FM) signal. It may be used in applications such as the remote control of garage doors, gates, lights, alarms or in any other new or existing installations where the use of conventional wiring is difficult or impossible to accomplish.

If the code of the input signal (from a transmitter) matches the setting of the coding switch on the receiver (up to 4096 combinations), an output is obtained i.e. the relay operates. This relay provides a clean set of contacts for switching current up to 10 Amps on 240 Volts.

Connection to the receiver is via a five-way screw-type terminal block, with a separate two-way screw-type terminal block for the antenna.

Elsema’s ANT27MHz series antennas will give a reliable control range of up to 200 metres, when used with Elsema’s FMT-301, FMT-302 and FMT-304 transmitters.

A push Button (designated as "TEST") is provided for relay output testing.

In the momentary mode (MOM) the relay is only activated while the correct signal is received. When changing the slide switch from "MOM" to "FF" (flip/flop mode) the output relay is toggled with every correct incoming signal. This enables the direct use for switching on/off lights etc. In flip/flop mode, the relay always energises at the initial "power-up".

If a "latching-on" output is required, for example receiver is used together with a "Panic Button", a wire link is to be fitted (See picture below). In such a case the relay can only be reset again by momentarily interrupting the supply.

Another feature available is a "delayed-off" output. To facilitate it, a small time unit DU-3 is to be fitted into the four unused holes. When ordering receivers with this function, please specify length of which may be between 1 second to 60 minutes. In this mode the relay energises when a correct code is received or the "TEST" is pushed, and de-energises after the time unit.

Care must be taken, not to bring a receiver near strong magnetic fields, such as DC-Motors, speakers, magnets for reed switches, transformers etc. as it would magnetise the coils and may cause severe de-tuning.